Ford Plug&Play engine remote start stop
Plug&Play can bus engine remote start stop for FordContact us National Advisory Hotline
|101FD||FORD (Support the car with Mechanical keys, But Ranger only support 2.4cc model)||F150||2015-2020|
|Ranger 2.2cc and 3.0cc,only support smart key||2019-2020|
|EVEREST, 2.0cc/2.2cc,only support smart key||2016-2020|
|Ecosport with push start button||2018-2020|
Match With Car Original Smart key
Step 1. Connect the A connector. Don't hit the
brakes, Click 2 times push button to ON
Notice: Pay attention to the LED status when you operate
Step 2. LED of main box will change to green
from Red, then turn off
Step 3 . Let push button of car OFF, Then
Remove cable A, then connect cable B
Step 4. Let push button of car ON again, Led
change to RED from Green, then off,
then Let Push button OFF again
Step 5 The matching is successful.
Reset the model when you use the model to new car
1. Power off car
2. Click small botton on the main box, and keep, don't release
3. Connect C cable with main box,the red led will shanling .
4. Release the button,then wait RED led turn off
Notice: Please operate reset step if you used the modeland matched it in car, then want to use it again in new car
A. Remote start engine by original key
Click 3 times Lock button, Car engine will be started.
B. Stop your engine by original key
Click 3 times Lock button again, Car engine will be stopped.
C. Warm your car early in the winter
If your car turns on the air conditioner early,
when you start the car by remote start module,
you can also turn on the heat inside the car.
D. Pre-refrigerate your car in the summer
If your car turns on the air conditioner early, you can turn on the air conditioner when you start the car.
How to exit the pause mode
1. We can check the main box if it goes into the pause mode and what's the pause mode:
Click 3 times lock button , The car's direction light blinks three times, three seconds after that, The car engine would not start and failed to restore factory Settings.
2. Exit pause mode:
Click original car Push start button from OFF to ON to OFF , and operate 5 times, Led of main box will blink 2 times, then will exit the pause mode.
Note: OFF-ON-OFF, it's 1 times. total 5 times.
Click 3 times lock button, car engine will be started