欢迎光临东莞九安电子科技有限公司官方网站!
联系我们 / 客诉反馈表 / 返回首页 / ENGLISH
新闻资讯
联系我们

东莞九安电子科技有限公司

地址:东莞万江水蛇涌美库产业园B4

电话:0769-22287912

传真:0769-22287167

全国服务热线: 400-072-1352 

服务邮箱:qx@tiremagic.cn

    站:www.tiremagic.cn 

主 营:胎压监测、胎压监测器
4常见问题

Can the cross section be filled with butter?


In the general car repair manual are clearly defined: the drive shaft telescopic sleeve of the key and the middle bearing the use of calcium-based grease, cross-needle bearings and three-axle drive the rear axle drive axle bearing the use of gear oil. However, in the actual work, due to no filling equipment, some repair workers in order to facilitate the map, the wrong use of calcium-based grease lubrication cross shaft needle roller bearings, resulting in a large number of cross bearing premature damage. As the universal joint cross shaft injection gear oil mouth is a very common butter mouth, often give people a misunderstanding, in fact, butter is not filling the needle on the needle. Because the butter viscosity is large, when the butter gun through the nozzle to the cross shaft cavity plus butter, the butter into the narrow oil tank oil resistance is very large, then the pressure will be the top of the nozzle to open the nozzle opposite the overflow valve, which So that the repair workers mistakenly believe that the bearing has been filled with oil, in fact, not only can not enter the needle between the needle, that is, to achieve the cross-journal face is also more difficult. Therefore, it should be changed with butter instead of gear oil lubrication universal joint cross shaft error practice, but should use gear oil pressure gun filling gear oil.
[返回]   
上一篇:没有啦!
Copyright © 2017-2018 东莞九安电子科技有限公司 版权所有   备案号:粤ICP备16090754号-1
全国服务热线: 400-072-1352      座机电话:0769-28821026    传真:0769-22287167
地址: 东莞万江水蛇涌振兴路117号美库产业园B栋4楼     邮箱:qx@tiremagic.cn